ELECTRICAL COMPONENTS
Fuse
12
FRONT DIFFERENTIAL LIMIT SWITCH REMOVAL
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2.
Raise the hood and remove the access panel.
3.
Locate front differential limit switch above accelerator pedal.
4.
Disconnect wire leads of switch (1) from wire harness.
5.
Remove the nuts (2) and screws (3) that secure the switch (1) and remove the switch.
FRONT DIFFERENTIAL LIMIT SWITCH INSTALLATION
1.
Install the front differential limit switch (1) in the reverse order of removal and tighten the nuts (2) to 4 in-lb (0.5
N·m).
See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, the switch could become damaged.
2.
Move the accelerator pedal back and forth to ensure that the switch lever is being properly activated.
3.
Connect wire leads of switch to wire harness.
4.
Connect battery and spark plug wire(s).
See Connecting the Battery – Gasoline Vehicles on page 1-4.
FUSE
See General Warning on page 1-2.
TESTING THE FUSE
See Test Procedure 2 – Fuse on page 11-15.
FUSE REMOVAL
1.
Raise the seat and remove the fuse cover located behind the battery.
2.
Remove the fuse from the fuse block.
FUSE INSTALLATION
1.
Install the fuse.
See following WARNING.
2009-2012 XRT 950 Maintenance and Service Manual
Page 12-9
