Club Car Turf 1 2006, Owner'S Manual

Page: 31 / 72

Bed Latch
2006 Turf Vehicle Owner’s Manual Page 29
ý
CAUT ION
• When stopped on a hill, use the brake pedal to hold your position. Do not use the accelerator
pedal.
To stop vehicle, release the accelerator pedal and press the brake pedal until vehicle comes to a complete
stop.
PARKING AND LEAVING THE VEHICLE
1. After coming to a complete stop, firmly press the park brake pedal until it locks. This will prevent the vehi-
cle from rolling.
2. Turn the key switch to the OFF position and place the Forward/Reverse handle or switch in the NEUTRAL
position. Remove the key.
• IQ System and IQ Plus vehicles only: When the Tow/Run switch is in the RUN position (with the For-
ward/Reverse switch or key switch in any position), the zero speed detect function will prevent the vehi-
cle from rolling at more than 1 to 3 mph (1.5 to 4.8 km/h) unless the accelerator is pressed. This
prevents the possibility of a parked vehicle (with the park brake disengaged) rolling away too fast to be
overtaken on foot.
• Gasoline vehicles only: Turn the fuel shut-off valve to the closed (OFF) position when the vehicle is
not in use.
BED LATCH
The electric and gasoline Turf 1 and Turf 2 are equipped with a bed latch on the driver side of the vehicle as
standard equipment
(Figure 19) . To lift the bed, pull the latch handle toward the rear of the vehicle and lift the
bed.
To close the bed, lower it gently until the bed latch engages. DO NOT drop the bed.
See following WARNING
and NOTE.
ý
WARNING
• Keep hands and fingers clear of crush area between the bed and the seat back support.
NOTE: The Turf 2 is equipped with an automatically engaging prop rod (Figure 20) , unless equipped with
the hydraulic or electric bed lift option.