Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 343 / 414

GASOLINE VEHICLE - FUEL SYSTEM Air Intake System
21
4. Remove the air filter (3) and dispose of properly.
5. Using a clean cloth, wipe away any dust or dirt from inside the air cleaner. Remove all dirt build-up around the
inside lip of the air cleaner housing or the cover will not seal properly.
6. Install new air filter, inserting the open end into the air cleaner housing first.
7. Check that the air intake gasket (4) is in place in the cover (2) and oriented correctly with the coated side of the
gasket facing toward the air cleaner housing.
8. Place the cover (2) over the air cleaner housing. Press firmly to engage the seals and rotate the cover
clockwise until the yellow tab is at the 11 o’clock position.
9. Press in the yellow tab (1) to lock the cover on the air cleaner. See following CAUTION.
CAUTION
• Engine damage will occur if the air filter cover is not properly secured.
• If air cleaner is extremely dirty, clean thoroughly.
• Use only Club Car replacement air filters or equivalent. The use of other air filters could result in engine
damage. If the air filter is too small, the cover will seat before the filter can seal, leaving space for dirt
to pass into the engine on all sides of the element. This will damage the engine and void the warranty.
1
2
3
4
2688
Figure 21-10 Air Filter
AIR INTAKE SYSTEM REMOVAL
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Access the engine compartment.
3. Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
4. Hose (3) may be removed by removing the clamps (4 and 5) at the air cleaner (1) and the throttle body (Figure
21-9, Page 21-14) .
2019 Precedent Villager 2 Maintenance and Service Manual Page 21-15