Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 274 / 414

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 20 – Fuel Pump
See General Warnings on page 1-2.
WARNING
• To avoid the possibility of fire or explosion, make sure the fuel tank cap is securely in place while
performing this test procedure.
NOTE: This is a voltage and resistance test.
2
4
3
1
WIRE FUNCTION WIRE COLOR
1. Fuel Pump Positive (+) Red Wire
2. Fuel Pump Negative (–) Black/White Wire
3. Sending Unit Positive (+) Orange Wire
4. Sending Unit Negative
(–) Black Wire
Black Wire
3031
Figure 18-12 Fuel Pump Module Terminals
Voltage to Pump
1. If necessary, see Testing Basics on page 18-10.
2. Disconnect the 5-pin connector from the top of the fuel pump module.
3. Check that battery voltage is present between ground and the red wire of the 5-pin connector immediately after
the key switch is placed in the ON position.
NOTE: The fuel pump and low oil warning light operate for a few seconds when key switch is turned to the ON
position; it stops if no engine RPM is detected by the ECU.
4. If no voltage, check key switch. See Key Switch (Start Circuit) on page 18-19.
Pump
1. If necessary, see Testing Basics on page 18-10.
2. Disconnect battery.
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
Page 18-32 2019 Precedent Villager 2 Maintenance and Service Manual