CONTROLLER DIAGNOSTIC TOOL (CDT)
Monitor Menu
11
ARMATURE PWM
Displays motor armature PWM (pulse width modulation). The range of pulse width modulation is 0% to 100%. When
the vehicle is operating at full speed, the pulse width modulation should be at 100%.
FIELD PWM
Displays motor field PWM (pulse width modulation). The range of pulse width modulation is 0% to 100%. When the
vehicle is in operation, the pulse width modulation will fluctuate in response to the terrain and throttle input.
SPEED PULSES
The
speed pulses
menu item displays the activity of the motor speed sensor. With the key switch in the OFF position,
the Forward/Reverse switch in the NEUTRAL position, and the vehicle at rest, the handset should indicate that
speed pulses are off. When the vehicle is gently pushed a short distance, the handset should indicate that speed
pulses are on.
FOOT INPUT
Indicates the status of the MCOR (Motor Controller Output Regulator) internal limit switch: on or off. When the
accelerator pedal is unpressed, the handset should indicate that the limit switch is off. When the accelerator pedal is
pressed and the key switch is in the ON position, the display should indicate that the limit switch is on.
KEY INPUT
Displays the position of the key switch: OFF or ON.
FORWARD INPUT
With the Forward/Reverse switch in the NEUTRAL or REVERSE position, the handset should indicate that the
forward input is off. When the Forward/Reverse switch is placed in the FORWARD position, the handset should
indicate that the forward input is on.
REVERSE INPUT
With the Forward/Reverse switch in the NEUTRAL or FORWARD position, the handset should indicate that the
reverse input is off. When the Forward/Reverse switch is placed in the REVERSE position, the handset should
indicate that the reverse input is on.
MODE SWITCH INPUT
This menu is reserved for possible future use and has no application at this time.
CHARGER INHIBIT
Displays charger connection. When the charger is connected and the controller does not drive (inhibited), the handset
indicates ON. When the charger is not connected and the controller is allowed to drive, the handset indicates OFF.
MAIN CONT DRIVER
Displays the present solenoid (main contactor) state. When the controller energizes the solenoid coil, the handset
indicates ON. When the controller de-energizes the solenoid coil, the handset indicates OFF.
LED DRIVER
Displays the present state of pin 11 in the controller 16-pin connector that operates the charge indicator light on the
dash. When pin 11 is activated, power is provided to the light and the handset indicates that the LED Driver is ON.
When pin 11 is not activated, the handset indicates that the LED Driver is OFF.
2019 Precedent Villager 2 Maintenance and Service Manual
Page 11-11
Summary of Contents for Precedent Villager 2
