Club Car Precedent 2014, Maintenance And Service Manual

Page: 69 / 548

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group – Electric Vehicle
5
• Test Procedure 8 – Key Switch and MCOR3 Limit Switch Circuit on page 13-20
• MCOR3 Removal on page 14-7
• MCOR3 Installation on page 14-7
PEDAL GROUP INSTALLATION
1. Connect the wire harness (12) to the MCOR3 (13) (Figure 5-2, Page 5-2) .
2. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1) on the
passenger side. Tighten driver side screws (2) to 97 in·lb (11 N·m). Tighten passenger side screws (1) to
18 in·lb (2 N·m).
3. Remove the turnbuckle (6) and apply Loctite ® 242 to the threaded ends of both the rod from the pedal group (8)
and the brake actuator rod (9). Connect the rods using the turnbuckle (6). Ensure the ends of the brake cables do
not slip out of the brake equalizer during this procedure.
4. Adjust the brake cable equalizer tension. See Brake Cable Equalizer Adjustment on page 6-10.
5. Place floor cover plate (7) over the floor opening and secure with fastener (10) (Figure 5-2, Page 5-2) .
6. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3). Tighten
screws (1) to 53 in·lb (6 N·m)
(Figure 5-1, Page 5-1) .
7. Connect batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
2014 Precedent ® Golf Car Maintenance and Service Manual Page 5-3