TORQUE CONVERTER
Drive Clutch
Page 17-8 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
17
Drive Clutch Disassembly, Continued:
6. Remove the retaining ring (3) from the shaft of the fixed face assembly (7) and slide the moveable face
(14) off the shaft (Figure 17-5, Page 17-6). See following NOTE.
NOTE: If the moveable face is removed from the hub of the fixed face, the spiral back-up rings (12) (Figure
17-5, Page 17-6) must be replaced with new ones.
7. Remove the spacer (16), and spring (4) and retainer (5). The spring retainer can be removed from the
spring if necessary (Figure 17-5, Page 17-6).
8. If necessary, remove idler bearing. Use a press to remove the bearing (Figure 17-10, Page 17-9). See
following NOTE.
NOTE: Do not remove the idler bearing unless it needs to be replaced. If idler bearing is removed, replace it
with a new bearing.
9. Use a scribe or small pick to remove the spiral backup rings (12) from each end of the bore in the fixed
face assembly (Figure 17-5, Page 17-6 and Figure 17-11, Page 17-9). Discard the rings.
Figure 17-8 Drive Button Mounting
Figure 17-9 Weight Position
Remove these
items from ribs:
10-24 SCREW
FLAT WASHER
DRIVE BUTTON
DRIVE BUTTON
TAKE UP SPRING
RIBS
WEIGHT
SLOTS IN HUB
CASTING
1/4-20 SCREW
FLAT WASHER
WEIGHT
