Club Car IQ PLUS 2008, Maintenance And Service Manual Supplement

Page: 87 / 164

ELECTRICAL COMPONENTS Forward/Reverse Rocker Switch
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 13-3
13
FORWARD/REVERSE ROCKER SWITCH
See General Warning, Section 10, Page 10-1.
Testing the Forward/Reverse Rocker Switch
See Test Procedure 16, Section 11, Page 11-41.
Forward/Reverse Rocker Switch Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove the center dash panel (Figure 13-1, Page 13-1) .
3. Remove the 18-gauge brown, orange, and blue wires from the rocker switch.
4. Press the locking tabs on each end of switch (11) and push switch out of dash panel.
Forward/Reverse Rocker Switch Installation
1. Press the locking tabs on each end of the rocker switch (11) and push switch into dash panel
(Figure 13-3, Page 13-4) .
2. Connect the 18-gauge brown, orange, and blue wires to the rocker switch exactly as shown in the wiring
diagram. See Wiring Diagrams, Section 11, Page 11-2.
3. Install center dash by reversing removal procedure. Make sure key switch terminals do not touch frame
and that the center dash panel is properly seated and snapped into place.
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation:
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is in the
FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch is in the
REVERSE position. The reverse buzzer will sound as a warning when the Forward/Reverse switch is
in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.