Club Car IQ PLUS 2008, Maintenance And Service Manual Supplement

Page: 41 / 164

ELECTRICAL SYSTEM AND TESTING Troubleshooting
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 11-27
11
CAUT ION
• Do not fully insert probes into the 24-pin plug. Doing so can result in a poor connection.
5. With the accelerator pedal fully up (not pressed), the multimeter should read approximately 1k ohms.
6. Slowly press the accelerator pedal while monitoring the multimeter. The resistance should rise as the
pedal is pressed. When the pedal is all the way to the floor, the multimeter should indicate between 5.67k
ohms and 7.43k ohms.
7. Set a multimeter to 20k ohms. Insert the red (+) probe of the multimeter into pin 15 (yellow wire) at the
24-pin connector. Connect the black (–) probe into pin 13 (white wire). See previous CAUTION.
8. With the accelerator pedal fully up (not pressed), the multimeter should indicate between 5.67k ohms
and 7.43k ohms.
9. Slowly press the accelerator pedal while monitoring the multimeter. The resistance should drop as the
pedal is pressed. When the pedal is all the way to the floor, the multimeter should indicate approximately
1k ohms.
10. If any other reading is observed, check the continuity of the wires in the wire harness.
Figure 11-18 Test: Pins 14 and 15 (Purple/White and Yellow wires)
Detail:
Front of 24-Pin Connector