Club Car FE 350, Maintenance And Service Supplement

Page: 207 / 280

S27 FE 350 FUEL SYSTEM Carburetor
16
CAUTION
• Make sure the fuel bowl is properly seated against the carburetor fuel bowl gasket, and the gasket
is not pinched.
1
4
5
1
3
2
1. If spring looks like this... 2. then adjust spring to look like this by... 3. holding float firmly and rotating valve counterclockwise to seat spring in
seat of float bowl 4. Check for coil located in groove above both ears. 5. Check for spring seated in recess of float.
538
Figure 16-5 Inspect Float Valve/Spring Assembly – Adjust If Required
11. Install the fuel bowl retaining screw and tighten it to 61 in-lb (6.9 N·m).
12. Write the size of the main jet on the fuel bowl with an indelible ink marker. This should be written in a location that
will be visible when the carburetor is installed on the engine.
13. Install the carburetor on the engine (Figure 16-1, Page 16-2) .
13.1. Attach the throttle return spring (11) to the carburetor and then to the throttle bracket (4) just before
positioning the carburetor and securing it to the engine.
13.2. Install the intake pipe gasket (16) (check for proper orientation) and intake pipe (17).
13.3. Install the carburetor retaining nuts (19) and tighten them to 50 in-lb (5.7 N·m).
14. Connect fuel supply line (26) and tighten screw clamp to 9 in-lb (1.0 N·m) (Figure 16-1, Page 16-2) .
15. Install carburetor vent line (14) and clamp (13).
16. Install the governor cable (30).
17. Install the intake hose (23) and secure with hose clamp.
NOTE: Make sure the intake hose is not twisted during installation.
18. Turn fuel shut-off valve on top of fuel tank to the ON position (Figure 16-21, Page 16-29 or Figure 16-22,
Page 16-29) .
19. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
20. Test drive the vehicle.
2009 FE 350 Maintenance and Service Supplement Page 16-5