13
Ignition Coil and Flywheel
S10 FE 350 ENGINE
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to loosen.
• Do not damage the fan blades with the strap wrench. Do not place screwdriver or pry bar in the
fan blades.
4.
Remove the flywheel with a puller (CCI P/N 1016627).
5.
Remove the flywheel key from its groove.
5
7
4
M
F
34
81
0.012 Inch
(0.304 mm)
6
532
Figure 13-9
Flywheel Nut
512
Figure 13-10
Adjust Ignition Coil Air Gap
FLYWHEEL INSTALLATION
1.
Insert the flywheel key into the keyway in the crankshaft. Then align the keyway in the flywheel to the key and
push the flywheel and fan assembly onto the crankshaft until it seats. Install flat washer and nut finger tight.
2.
Use a strap wrench (3) to keep the flywheel and fan assembly (1) from turning while tightening the flywheel nut to
63 ft-lb (85.4 N·m)
See following CAUTION.
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to loosen.
• Be careful not to damage the fan blades. Use a strap wrench to hold flywheel. Do not place screwdriver
or pry bar between fan blades.
3.
Install the fan housing and tighten the screws to 90 in-lbs (10 N·m).
Page 13-8
2009 FE 350 Maintenance and Service Supplement
