Club Car DS Villager 4, Maintenance And Service Manual

Page: 352 / 510

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 11 – Starter/Generator (Starter Function)
NOTE: Observe the following before testing the starter/generator:
• This is only testing continuity.
• Tag the starter/generator wires for identification before disconnecting.
• Remove starter/generator wire from one of the “A” terminals and one of the “F” terminals if testing while
starter/generator is in vehicle.
• When disconnecting wires from starter/generator terminals, use a second wrench on the lower nut of
the terminal post to hold post steady.
• Scrape a small amount of paint from starter/generator housing (ground) and use this location when testing
motor terminals to electrical ground.
_
MOTOR TERMINALS CONTINUITY TEST
RESULT
A1 to A2
F1 to F2
Continuity
A1 to F1
A1 to F2
No Continuity
A2 to F1
A2 to F2
No Continuity
A1 to Ground
A2 to Ground
No Continuity
F1 to Ground
F2 to Ground
No Continuity
1. If necessary, see Testing Basics.
2. Disconnect the battery and spark plug wire.
3. Disconnect the wires from all the terminals on the starter/generator.
4. Set the multimeter to 200 Ohms.
5. Put the black (–) probe on the starter/generator housing. Scratch through the finish to ensure a good ground.
Page 18-18 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual