Club Car DS Villager 4, Maintenance And Service Manual

Page: 195 / 510

CONTROLLER DIAGNOSTIC TOOL (CDT) Monitor Menu
11
AMP HOURS DISPLAY
Signed Battery Current
While driving the vehicle, this displays either the current being pulled out of the batteries or the current being returned
to the batteries during regenerative motor braking. It has a range from negative (–) 300 amps to positive (+) 300 amps.
Amp Hours
Displays total accumulated amp hours removed from batteries since initial vehicle start-up.
Regen Amp Hours
Displays total accumulated amp hours returned to the batteries from regenerative braking since initial vehicle start-up.
Charge Amp Hours
Displays amp hours removed from batteries since the last charge.
Charge Regen Amp Hours
Displays amp hours returned to the batteries from regenerative braking since the last charge.
Trip Amp Hours
Displays amp hours removed from batteries since trip amp hours was reset. See Reset Trip Amp Hours on page 11-8.
Trip Regen Amp Hours
Displays amp hours returned to the batteries from regenerative braking since trip amp hours was reset.
LIN
Relates to communication between the controller and the Guardian/Visage device (if equipped).
Charger
Additional
VEHICLE SPEEDS
Press right arrow to display programmed speeds for each speed setting. See Code A, Code B, and Code C on
page 11-8.
PEDAL COUNTERS
Accumulates accelerator pedal usage.
FAULT COUNTERS
The Fault Counters indicate how many times each fault type has been recorded since the last clearing of fault history.
See following Faults Menu section.
FAULT COUNT ODOMETERS
The Fault Count Odometers indicate the odometer reading associated with the last occurrence of each fault type. Will
indicate 0.0 (miles) if the fault occurred before the last clearing of fault history.
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 11-13