Club Car Carryall XRT 1550, Maintenance And Service Manual

Page: 235 / 432

ELECTRICAL COMPONENTS: GASOLINE
VEHICLES Fuse
13
TESTING THE LIGHT SWITCH
See Test Procedure 33 – Light Switch on page 11-33.
LIGHT SWITCH REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Raise the hood.
3. Press the upper and lower retaining tabs and push the light switch (11) out of the instrument panel (Figure
13-6, Page 13-7) .
4. Disconnect the wire harness from the light switch.
LIGHT SWITCH INSTALLATION
1. Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2. Push the light switch into the instrument panel until fully seated.
3. Lower and secure the hood.
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
FUSE
See General Warnings, Section 1, Page 1-2.
TESTING THE FUSE
See Test Procedure 2 – Fuse on page 11-11.
FUSE REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Remove the electrical component cover (located near the battery) and remove the fuse from the fuse block.
FUSE INSTALLATION
1. Install the fuse. See following WARNING.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 13-11