WHEEL BRAKE ASSEMBLIES
Rear Brake Cables
6
REAR BRAKE CABLE REMOVAL
1.
Chock wheels to keep vehicle from unintentionally moving.
2.
Release park brake if latched and loosen equalizer retaining nuts (13 and 14) on equalizer rod (2) to slightly
loosen brake cables (7)
.
3.
Rotate brake cables (7) upward and pull ends through holes in top of equalizer (3).
4.
Disconnect brake cables (7) at rear wheels.
4.1.
Remove bow-tie pins (8), clevis pins (5), and E-clips (6)
.
4.2.
Remove cable (7) from plate under leaf spring.
4.3.
Note location of hangers (11) and pull cables out of vehicle.
REAR BRAKE CABLE INSTALLATION
1.
Place the cable ends in the equalizer (3)
. Route cables through hangers (11) in
the same manner as the ones removed.
2.
At the rear wheel brakes, connect the cables (7) to the brake actuator arms using clevis pins (5) and new
bow-tie pins (8).
3.
Place cables (7) in plate under leaf springs and secure with E-clips (6).
4.
Adjust brakes.
See Brake Adjustment on page 6-6.
2017 Carryall 500 and 700 Maintenance and Service Manual
Page 6-17
Summary of Contents for Carryall 500
