20
Fuel Level Sending Unit
ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE
4.
Alternate pulling the lower and upper tabs away from the gauge housing to remove clip. Pull gauge/meter
from the instrument panel.
FUEL GAUGE/HOUR METER INSTALLATION
1.
Install a new fuel gauge/hour meter (6) into the hole in the instrument panel until the flange seats against the
instrument panel
.
2.
Connect the wires to the fuel gauge/hour meter.
See Wiring Diagrams on page 18-8.
3.
Install the instrument panel.
See Instrument Panel Installation, Section 4, Page 4-10.
Be sure that key switch
terminals cannot touch the frame and that panel is properly seated and snapped in place.
4.
Connect battery and spark plug wire(s).
See Connecting the Battery-Gasoline Vehicles on page 1-5.
FUEL LEVEL SENDING UNIT
See General Warnings on page 1-1.
The fuel level sending unit is an integral part of the fuel pump module and is not replaceable. Thoroughly test the fuel
level sending unit before replacing the fuel pump module.
TESTING THE FUEL LEVEL SENDING UNIT
See Test Procedure 22 – Fuel Level Sending Unit on page 18-39.
OIL LEVEL SENSOR
See General Warnings on page 1-1.
TESTING THE OIL LEVEL SENSOR
See Test Procedure 19 – Oil Level Sensor on page 18-37.
OIL LEVEL SENSOR REMOVAL
See Oil Level Sensor Removal on page 22-12.
OIL LEVEL SENSOR INSTALLATION
See Oil Level Sensor Installation on page 22-12.
VOLTAGE LIMITER
See General Warnings on page 1-1.
TESTING THE VOLTAGE LIMITER
Page 20-28
2017 Carryall 500 and 700 Maintenance and Service Manual
Summary of Contents for Carryall 500
