Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 416 / 596

21
Engine Control Linkages GASOLINE VEHICLE - FUEL SYSTEM
CLOSED THROTTLE OR IDLE ADJUSTMENT – PEDAL-START VEHICLES
To adjust the idle, see ECU Reset Procedure and TPS Learn Procedure for Pedal Start Applications in the
Kohler Service Manual.
CLOSED THROTTLE OR IDLE ADJUSTMENT – KEY-START VEHICLES
To adjust the idle, see ECU Reset Procedure and TPS Learn Procedure for Key Start Applications in the
Kohler Service Manual.
HOW TO MEASURE GROUND SPEED
Best Method
An easy way to check ground speed is by using a GPS device or smartphone application (app). If these are not
available, use the alternate method below.
Alternate Method (Calculated)
Ground speed is easily determined by a known distance travelled, divided by the amount of time it took to travel that
known distance (
Rate = Distance/Time ).
1. Establish a known distance to travel (example: 100 ft. (30.5 m) in a safe location using cones or other type of
marker.
2. Drive vehicle and bring to maximum speed before reaching the first cone.
3. Using a stopwatch, record the amount of time it takes to travel from the first cone to the second cone at maximum
speed.
4. With distance and time determined, calculate ground speed:
4.1. Rate in seconds: Divide distance (100 ft (30.5 m)) by time (5 seconds) = 20 ft/sec (6.1 m/sec).
4.2. Convert seconds to hour: Multiply 20 ft/sec (6.1 m/sec) by 3600 (the number of seconds in an hour) =
72000 ft/hour (21960 m/hour)
4.3. Convert to MPH: Divide 72000 ft/hour by 5280 (number of ft in 1 mile) = 13.64 miles/hour
Convert to KPH: Move the decimal point over three places; 21960 m/hour = 21.96 km/hour
ENGINE RPM ADJUSTMENT
DANGER
• Do not operate gasoline vehicle in an enclosed area without proper ventilation. The engine produces
carbon monoxide, which is an odorless, deadly poison.
1. If governor is adjusted, go to step 2; otherwise, adjust governor. See Governor Cable Installation and Adjustment.
2. Connect the battery and spark plug wire.
3. Measure vehicle ground speed. See How to Measure Ground Speed.
4. Compare measured ground speed with forward ground speed specified in Vehicle Specifications..
5. If adjustment is necessary, use the following procedures:
5.1. To reduce RPM, loosen the accelerator cable jam nut on the outside of the electrical component box
and tighten the jam nut on the inside of the box until specified ground speed is reached. See Vehicle
Specifications.
5.2. To increase RPM, loosen the jam nut inside the electrical component box and tighten the jam nut outside
the box until specified ground speed is reached.
Page 21-10 2021 Carryall 300 Maintenance and Service Manual