Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 343 / 596

GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM Test Procedures
18
TEST PROCEDURE 30 – Maintenance/Operate Switch – Key-Start Vehicles
See General Warnings on page 1-1.
NOTE: This is a continuity test.
The Maintenance/Operate Switch is also known as the Neutral Lockout Switch.
1. If necessary, see Testing Basics.
2. Remove the wires from switch.
T1 T3 T2
2 1
1. Position 1 (MAINT.)
closes T2 to T3
Toggle Position Operates:
2. Position 2 (OP.) closes
T1 to T2
3. T1 – Blue/White Stripe; T2 – Black
478
Figure 18-29 Maintenance/Operate Switch Test – for
Key-Start Vehicles
3. Set the switch to MAINTENANCE (1) (Figure 18-8, Page 18-19) :
3.1. Check for no continuity between terminals T1 and T2. If there is continuity, replace the switch.
3.2. Check for continuity between terminals T2 and T3. If there is no continuity, replace the switch.
4. Set the switch to OPERATE (2):
4.1. Check for no continuity between terminals T2 and T3. If there is continuity, replace the switch.
4.2. Check for continuity between terminals T1 and T2. If there is no continuity, replace the switch.
5. If the switch works as stated and the MAINTENANCE/OPERATE modes still do not work:
5.1. Check the limit switches.
5.2. Check continuity of the wires involved.
2021 Carryall 300 Maintenance and Service Manual Page 18-45