Club Car CARRYALL 272, Maintenance And Service Manual

Page: 49 / 312

ACCELERATOR AND BRAKE PEDAL ASSEMBLIES Accelerator Pedal Adjustment
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 5-7
5
7. Adjust the accelerator rod.
7.1. Remove the electrical box screw and cover (Figure 5-10, Page 5-8) . See the preceding WARN-
ING.
7.2. Loosen the jam nuts (18) and disconnect the accelerator rod (17) at the accelerator pedal
(Figure 5-11, Page 5-9) . Adjust the length of the rod so the indicated cam edge is parallel with the
edge of the electrical component box (Figure 5-10, Page 5-8). See following CAUTION.
ý
CAUTION
• After accelerator rod adjustment, make sure approximately the same amount of thread is
exposed at each end of the rod.
• If lever on the limit switch in the electrical box is bent, replace limit switch.
• When loosening jam nuts on the accelerator rod with one end disconnected, hold the
disconnected accelerator rod with locking pliers.
• When tightening jam nuts on the accelerator rod, hold the disconnected ball joint with locking
pliers.
Figure 5-7 Accelerator Pedal Height Figure 5-8 Accelerator Pedal Adjustment
Figure 5-9 Accelerator Pedal Height Adjustment
GO
ST
OP
1 2
3
4
5
6
7
8
9
10
Correct pedal position
is 5-3/4 in. ±1/4 in.
(14.6 cm ±6 mm) from
floormat to back of
accelerator pedal
1/2 IN. SOCKET
1/2 IN. WRENCH
ST
OP
GO
ACCELERA
TOR
PEDAL HEIGHT
YOUN
G DR
IVERS
INCR EASE
CHAN
CE O F DEA
TH
• Youn
g drive rs may
not be
able to
contro l vehic
le.
• No d
rivers y ounge
r than 1
6 years
old.
• Do n
ot leav e child
ern un
attend ed on v
ehicle.
UNDE
R
16
WARN
ING
WARN
ING
ROLLO
VER O
R FA LLIN
G OFF
MA Y
CAU
SE D
EATH
• Read
opera
tors m anual a
nd ope
rating i nstruc
tions.
• Rem
ain se ated a
nd hold
on to s
eat ha ndle w
hile m
oving.
• Drive
slowly
in turn s and s
traight
up and
down slope
s.
• Do n
ot star t vehic
le until
all oc
cupan ts are s
eated.
• One (
1) pers
on per seat m
aximu
m.
• Oper
ate fro
m driv er side
only a
nd not on pub
lic roa
ds.
• Keep
entire
body i nside v
ehicle
while movin
g.
• Do n
ot use
differe ntial lo
ck on p
aved s urface
s.
• Do n
ot ope rate w
hile un
der the
influe nce of
alcoho
l or dru gs.
OFF
ON
¥ Read Ow
ner's Manua
l and safety w
arnings loca
ted on dash
panel prior t
o driving.
¥ Study and
understand
controls.
¥ To start e
ngine:
Ð Place shift l
ever in ÒNÓÐ
Neutral pos
ition.
Ð Depress bra
ke pedal. Ð Turn key sw
itch to ÒSTA
RTÓ positio
n and releas
e.
¥ To opera
te vehicle
: Ð Make sure
wheels are t
urned in des
ired direction
.
Ð Be sure no
thing is in yo
ur path.
Ð While vehic
le is stopped
, select vehic
le direction b
y placing
shift lever or
switch in de
sired positio
n.
F Ð Forward
N Ð Neutra
l R Ð Rev
erse (Buzze
r will sound)
Ð Park brake
will release
when accele
rator pedal is
pushed.
Ð Slowly pus
h accelerato
r pedal to in
crease spee
d.
Ð Accelerato
r pedal must
be released
to shift vehic
le to neutral.
¥ To stop v
ehicle:
Ð Release ac
celerator pe
dal and push
brake peda
l.
Ð After stopp
ing, firmly pu
sh park brak
e until it lock
s.
Ð Turn key to
ÒOFFÓ po
sition, remov
e key and pla
ce shift
lever in straig
ht up neutra
l position w
hen not in u
se.
CCI 101
6932-01
OPERA
TING INSTR
UCTIONS
STOP
GO
ACCELERATOR
PEDAL HEIGHT
ACCELERATOR PEDAL
ADJUSTMENT TOOL
(CCI P/N 101871001)
RUBBER STRAP