S10 FE 350 FUEL SYSTEM
Fuel Tank
17
WARNING
• Make sure the key switch is off before disconnecting wiring.
9.
Remove the vent tube (6) and fuel line (1) from the fuel tank
10. Loosen the strap (13) by removing the screw (12) from the speed nut (11).
11. Remove the filler neck from the polyurethane filler bezel.
12. Lift the fuel tank out of the vehicle.
549
Figure 17-16
Fuel Level Sending Unit
FUEL TANK DISPOSAL
1.
Remove the cap from the tank and thoroughly rinse it with water. The cap may be discarded or kept as a spare.
2.
In a well-ventilated area, flush the fuel tank with water to remove any remaining fuel.
3.
In a well-ventilated area, set the tank upside down so that the water can drain out of it. To make sure that the tank
dries completely, allow the tank to sit for 24 hours.
See following CAUTION.
CAUTION
• Dispose of wastewater and fuel tank in accordance with local, state, and federal laws and ordinances.
FUEL TANK STORAGE
1.
Remove the cap from the tank and thoroughly rinse it with water.
2.
In a well-ventilated area, flush the fuel tank with water to remove any remaining fuel.
3.
In a well-ventilated area, set the tank upside down so that the water can drain out of it. To make sure that the tank
dries completely, allow the tank to sit for 24 hours.
4.
Store the tank upside down, with the cap installed, in a well-ventilated area.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Page 17-23
