TROUBLESHOOTING AND ELECTRICAL SYSTEM:
PEDAL-START GAS VEHICLE
Test Procedures
12
TEST PROCEDURE 5 – Accelerator Pedal Limit Switch
See General Warning on page 1-1.
The accelerator pedal limit switch is the top switch located in the electrical component box. There is an 18-gauge
green wire and an 18-gauge orange wire connected to this limit switch.
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles, Section
2.
Check for proper wiring and tight connections
3.
Set the multimeter to 200 ohms. Place the red (+) probe on the common (COM) terminal (green wire) of the limit
switch and place the black (–) probe on the normally closed (NC) terminal (orange wire) of the limit switch.
4.
Make sure the battery is disconnected. With the key switch in the OFF position, the Forward/Reverse handle in
NEUTRAL, and the accelerator pedal in the UP position, the reading should be no continuity. With the accelerator
pedal pressed, the reading should be continuity. If readings are incorrect, replace the switch.
1
2
3
4
5
6
1. Cover 2. Electrical Component Box 3. 6 Ga. White Wire 4. 18
Ga. White Wire 5. 18 Ga. Red Wire 6. Solenoid
457
Figure 12-10
Solenoid Wire Removal
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Page 12-15
