Club Cannon SHOMASTER, User Manual

Page: 5 / 38

BANK NAME BANK MODE START CH END CH CH COUNT
BANKS CANNOT HAVE OVERLAPPING DMX CHANNELS.
THE AUTO ADDRESS BUTTON WILL PARSE YOUR BANK’S DMX ADDRESSES TO THE LOWEST AVAILABLE SLOT.
NOTE: IF YOU WOULD LIKE TO USE AUTO ADDRESS WITHOUT CHANGING CERTAIN BANKS ADDRESSES, USE THE LOCK FUNCTION.
VALUES DISPLAYED IN RED MUST BE CORRECTED BEFORE PROCEEDING.
SAVE & EXIT
WE’RE ALL SET.
AUTO ADDRESS
I’LL FIGURE IT OUT FOR YOU.
DEVICE PATCH
4 ZONE
STREAMERS
CONFETTI
DS CRYO
CRYO LED
4 ZONE
4 ZONE
JET+LED
1
5
9
13
4
8
12
22
4
4
4
10
BACK
DESCRIPTION NAME CHANNELS KEY CH
TANK CALCULATOR
DAISY CHAINED TANKS
DISPLAY STYLE
SELECT YOUR DESIRED STYLE
BUTTON SETTINGS
TAP ICON TO CHANGE COLOR
CURRENT TANK VALUES
NO TANKS / SEPARATE TANK
LB KG
REFILL #1 REFILL #2 REFILL #3 REFILL #3
ADD TO TIME ADD TO TIME ADD TO TIME ADD TO TIME
DMX ADDRESS
SET STARTING ADDRESS
SET MODE
FOR THIS BANK
HOLD MODE HOLD MODE HOLD MODE HOLD MODE
20LB 50LB 75LB CLEAR
DISABLE BANK
ALSO TURNS OFF BUTTON LEDS
SAVE & EXIT
IT’S SHOTIME.
100 100 100 100
SECONDS
JETS
TANKS
4 ZONE
DS CRYO
JET 1 JET 2
2
30
4
60 60 60 60
JET 3 JET 4
001
REFILL ALL
WITH ABOVE VALUE
BOOT SHOMASTER
The ShoMaster accepts 110-240v AC. If you plan to utilize the
AC Outputs, make sure the connected equipment’s voltage
requirement matches the input voltage being sent to the
ShoMaster.
1.
SET ADDRESSES
Each bank has a starting DMX address. Banks cannot overlap
addresses. Use the patch menu to automatically calculate
available addresses, then set your equipments addresses
accordingly. If desired, addresses can be set manually as well.
3.
IT’S SHOTIME
Now that all modes, addresses and cues have been configured,
it’s time to start the show.
Read through the entire manual for additional capabilities.
5.
SET MODES
Select the mode(s) that match the equipment you plan to
operate. There are several preset modes available, however
if no preset mode fits the necessary channeling, configure a
custom mode. (Instructions below).
2.
CONFIGURE CUES
The last step is to configure cue names, colors, timers and
bump/hold options. These settings can be accessed on the
bank settings page. To access, press the cog wheel inside
desired bank on the homepage.
4.
QUICK START GUIDE
1