6. Turn the power on and see if the HDD is being recognized.
6.2 INSTALL THE HDD2
NOTE
If the HDD is not recognized after installing, please check the HDD jumper setting,
power cable and data cable connection.
CAUTION
TO INSTALL A HARD DISK DRIVE (HDD) FOR SLAVE, UNPLUG
THE AC POWER CORD AS THIS CAN RESULT IN A RISK OF
ELECTRIC SHOCK.
The HDD2 (SLAVE) can be installed inside of the system.
The power switch must be turned off and unplug the power cord to prevent an electric shock may
happen.
1.
Attach the supplied HDD bracket on both side of the HDD and secure it with the supplied
screws as below.
2. Remove the cover and screws on both side and back of the system.
3. Place the HDD (for slave) on the inside of the back cover of the system and secure it with the
supplied screws as follows.
- 39 -
