Cloos QINEO, Operating Instructions Manual, Page: 96 / 186

96
MAIN (2) - Diagnostics
Select signals
Use rotary knob 3 to select a signal place for an input or output in the I/0
menu (1-10).
Press the rotary knob to change to the selection mode. The storage space is
highlighted in green. Select the appropriate input or output by turning the
rotary knob. By pressing the rotary knob again, the selected function for
this signal place is determined.
If the signal state is 1 (On), the box in front of the input or output is high-
lighted in yellow. If the signal state is 0 (Off), a white framed box only is
visible.
By means of the function "Change signal state" the manual input of sig-
nals can be activated. The signal state can be switched on or off by using
the "On" or "Off" function. If the input or output is active, the box is shown
red framed. Pressing the "Normal" function resets the signals to their origi-
nal state, see Figure 55.
Job selection
The history of the jobs called up by the welding power source can be made
visible on the right part of the display under "Job selection".
11.4 Diagnostics VBC module
If the welding power source is equipped with a VBC module, this is indi-
cated in the menu "Diagnostics" --> "I/O" by the menu item "VBC".
If the VBC module has a ProfiNet interface, the menu item "ProfiNet” ap-
pears in the submenu "Diagnostics I/O" -> "VBC".
Diagnose VBC
ProfiNet
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Diagnose VBC
Figure 56. Diagnostics VBC menu