Cloos QINEO, Operating Instructions Manual, Page: 147 / 186

147
1.1 Error list
No.
Error message on the
display
Possible cause Remedy
1 CAN connection faulty
Interruption of CAN bus between
control and operating module
 Check plug and connections to the
operating module

Service
2
Error when loading
the job data of the
operating module
Operating module cannot call up
the information of the control.

Switch machine Off and On

Check cable connections
 Service
3
Error when loading the
minimum values of the
operating module
Operating module cannot call up
the information of the control.
 Switch machine Off and On
 Check cable connections
 Service
4
Error when loading the
maximum values of the
operating module
Operating module cannot call up
the information of the control.
 Switch machine Off and On
 Check cable connections

Service
5
Error when loading the
configuration of the
operating module
Operating module cannot call up
the information of the control.

Switch machine Off and On

Check cable connections
 Service
6
Error when loading the
job list Operating module cannot call up
the information of the control.
 Switch machine Off and On
 Check cable connections
 Service
7
Error when loading the
version data Operating module cannot call up
the information of the control.
 Switch machine Off and On
 Check cable connections

Service
8
Error during
transmission of the
option code
Operating module cannot call up
the information of the control.

Switch machine Off and On

Check cable connections
 Service
9
Characteristic curve
allocation error (only
Eco-Master operating
modules) May appear after loading new
characteristic curves if material/gas
combinations in the config are set
incorrectly.
 Call up characteristic curves again
 Check characteristic curve allocation

Service
10
Job does not contain any
data
Job does not exist in the controller.
May appear in case of external job
selection
 Check job selection
 Create new job
 Service
11
Job has wrong check
sum
Error in job file.
 Check job selection
 Create new job
 Service
14
No valid characteristic
curve on weld start
Invalid material/gas combination
and/or process selection.
• ECO/Master: Material/gas LEDs
are blinking.
• Premium: Parameters in the
main menu are shown in red.

Select valid characteristic curve
 Service
15
Error in the offsets of
current and voltage
measurement
Error in the digital signal processor
(DSP).
 Switch machine Off and On

Service