Cloos NexT 452 AC, Operating Instructions Manual

Page: 70 / 234

70
MAIN (2) - Config (Configuration)
The determined values can be re-adjusted manually if necessary.
An optimum compensation of the external welding current circuit has
been reached if – in the case of correct welding parameters – the values for
Fine adjustment "ArcLength" and "ArcDynamic" are set to max. -10…10.
9.4 Access rights
9.4.1 Config - Access management
The welding power source is provided with an access management system
as standard. Different access rights and user rights for the welding power
source are included in this management system.
• Use the arrow symbols to switch between the individual menu items.
The access management of the welding power source has 3 operating
levels "Automatic", "Programmer" and "Configurator".
Automatic
The user with the "Automatic" operating level can look at the individual
functions. Access to the preset values is blocked.
The user with "Automatic" operating level does not need an access code!
Programmer
The user with the "Programmer" operating level can call and look at
the individual functions. He has an active access right to all welding
parameters.
The user must register with an 8-digit code number.
Configurator
The user with the "Configurator" operating level can call and look at the in-
dividual functions. He has an active access right to all preset values includ-
ing access to the synergy characteristic curves.
Speichern
in 4
Speichern
in 1
Speichern
in 3
Speichern
in 2
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Konfig - Kompensation
Schweißkreis 1
6.7
Widerstand R [mOhm]
Induktivität L [wH] 14.4
Schweißkreis 2
5.4
Widerstand R [mOhm]
Induktivität L [wH] 12.3
Schweißkreis 3
7.1
Widerstand R [mOhm]
Induktivität L [wH] 15.5
Schweißkreis 4
0.0
Widerstand R [mOhm]
Induktivität L [wH] 0.0
Display Konfig Kompensation
Mess-
Vorgang
freigeben
Mess-
Vorgang
starten
Figure 40. "Config" - "Compensation" menu