CLIVET WSAN-YMi 101, Instruction Manual For Installation, Use And Maintenance, Page: 56 / 128

The installer is obliged to verify correct operation of unit after
installation.
Final check
Before switching on the unit, read following recommendations:

When the complete installation and all necessary settings
have been carried out, close all front panels of the unit
and refit the unit cover.

The service panel of the switch box may only be opened
by a licensed electrician for maintenance.
NOTE
That during the first running period of the unit, required
power input may be higher than stated on the nameplate of
the unit.
This phenomenon originates from the compressor that
needs elapse of a 50 hours run in period before reaching
smooth operation and stable power consumption.
Test run operation (manual)
If required, the installer can perform a manual test run
operation at any time to check correct operation of air purge,
heating, cooling and domestic water heating, refer to TEST
RUN.
After setting the address, you need to press the “UNLOCK”
key to confirm.
The address “FF” is an invalid address code.
When HMI SET is set to SLAVE, the controller can only
switch the operation mode, turn on or off, set the temperate,
and cannot set other paramters and functions.
The address “FF” is an invalid address code.