CLIVET WSAN-YMi 101, Instruction Manual For Installation, Use And Maintenance

Page: 31 / 128


Use a round crimp-style terminal for connection to the power supply terminal board. In case it cannot be used due to unavoidable
reasons, be sure to observe the following instructions.

Do not connect different gauge wires to the same power supply terminal. (Loose connections may cause overheating.)

When connecting wires of the same gauge, connect them according to the figure below.

Use the correct screwdriver to tighten the terminal screws. Small screwdrivers can damage the screw head and prevent
appropriate tightening.

Over-tightening the terminal screws can damage the screws.

Attach a ground fault circuit interrupter and fuse to the power supply line.

In wiring, make certain that prescribed wires are used, carry out complete connections, and fix the wires so that outside force
cannot affect the terminals.
Door 1: compressor compartment and electrical parts: XT1
Stated values are maximum values (see electrical data for exact values).
NOTE
The ground fault circuit interrupter must be a high-speed type breaker of 30 mA (<0.1 s).
Unit (kW)
3-phase
18 22 26 30
Maximum overcurrent protector (MOP) 37.8 44.1 48.6 51.3
Wiring size (mm
2
) 6 6 10 10
Procedure for all connections

Connect the cable to the appropriate terminals as shown in the picture.

Fix the cable with cable ties to the cable tie mountings to ensure stress relief.