Climax FF6300, Operating Manual

Page: 42 / 132

Page 26 FF6300 Operating Manual
NOTICE
Keep the shipping container and all packing materials for future storage
and shipping of the machine.
The machine ships from CLIMAX with a heavy coating of LPS 3. The recommended
cleaner is LPS PreSolve Orange Degreaser.
3.2 P
REPARING THE MACHINE FOR USE
3.2.1 Pre-setup check
The FF6300 can be set up and mounted in many ways. Before setting up the flange
facer, check the following:
• The machine assemblies are positioned correctly.
• There is enough room to position the entire machine on or near the work
piece.
• All connections are correctly attached.
3.2.2 Assessing the work area
The FF6300 often is used in dangerous locations (in elevated positions, near other
operating equipment, overhead, etc.). CLIMAX cannot foresee where this machine
will be used; therefore, you must perform a site-specific risk assessment (Section 1.5
on page 6 and Section 1.6 on page 7) for each job before starting work.
The FF6300 machine has remote operation features that enable you to choose the
optimum location to work (Section 2.3 on page 21).
WARNING
Always follow safe work practices, including site-specific safety
requirements. It is your responsibility to perform a risk assessment before
you set up the machine and each time before you operate the machine.