Climax BB4500, Operating Manual

Page: 75 / 162

P/N 92974, Rev. 1 Page 59
5.3 M
AINTENANCE TASKS
Maintenance tasks are described in the following sections.
5.3.1 AFU
Clutch performance may be compromised if the machine has been “crashed,” has
seen over a thousand hours of operation, or is operated in a dirty environment.
If the axial feed fails, check that the shear pins are intact. Extra pins are included
with the assembly. The pins must be in place (notched end out) to engage the feed.
NOTICE
Freezing temperatures may cause the axial feed box to run sluggishly.
5.3.2 Boring bar
Check the bar regularly for nicks, cuts, or abrasions. Dress the bar smooth if neces-
sary. A bar with nicks or gouges can damage the bearing supports and RDU
beyond repair. Wipe the bar clean with solvent to remove dirt and chips.
5.3.3 Hydraulic power system
For information on maintaining the hydraulic power system, see the manufac-
turer’s documentation for your hydraulic system.
Air motor AW 32 6 oz
Per use through
the lubricator
ACME screw
Boring bar
Tool heads
Unpainted surfaces
WD 40
As
required
Per use by hand
Cutting fluid DoAll AL2000
As
required
As required
Long-term rust pre-
ventative
LPS-3
As
required For storage more
than 3 months
Tool bits, work piece Koolkut
As
required
Per use by hand
T
ABLE
5-2. A
PPROVED LUBRICANTS
(C
ONTINUED
)
Application Area Lubricant Quantity Frequency