1
Mini Smoke Detector (Mini-SD-HME) User Manual
Mini-SD-HME is a mini-sized wireless smoke detector with built-in PIR motion sensor, heat detector and emergency light.
Mini-SD-HME is designed to protect your family against potential fire hazard.
Parts Identification
1. IR lens
2. LED Indicator & Learn/Test Button/Emergency Light
Red LED
Quick flash: Alarming
Flashes every 1 second: Sleep Mode.
Flashes every 2 seconds: Under warmup and calibration process.
Flashes every 4 seconds with Orange LED: battery exhausted.
Flashes briefly: When Learn Button is pressed to see if the device is functioning normally.
Lights up briefly: Transmitting signal.
Flashes 2 times: When receiving acknowledgement from the Control Panel.
Orange LED
Flashes every 4 seconds with RED LED: battery exhausted.
Flashes every 5 seconds: Calibration Failure
Flashes every 45 seconds: Low battery condition
Learn/Test Button
Press the button once to:
Send a supervision / test signal.
Check smoke detection chamber.
Silence alarm.
Emergency Light
The emergency light will be turned on simultaneously when an alarm is triggered.
3. Buzzer
4. Mounting Holes
5. Battery compartment
6. Hooks
7. Mounting Holes
Getting Started
Step 1.
Put the Control Panel into learning mode. Refer to the Control Panel manual for details.
Step 2.
Insert battery to power on the Mini Smoke Detector.
Step 3.
The Mini Smoke Detector will emit 2 short beeps and begin warm up for
1
minute. The Red LED will flash
every 2 seconds.
Step 4.
During the 1 minute period, press the Learn/Test button once to transmit learn code. The Mini Smoke
Detector will emit a 2-tone beep. Refer to Control Panel manual to complete learning process.
Step 5.
When the Mini Smoke Detector completes warm-up, it will emit a beep to indicate it has entered
calibration mode. The calibration mode lasts for
1~9
minutes. The Red LED will continue to flash every
two seconds during calibration. Learning the Mini Smoke Detector is
prohibited
during this period.
Step 6.
When calibration is completed, the Mini Smoke Detector will emit 2 short beeps and turn off LED to return
to normal mode. If the Mini Smoke Detector is not learnt into panel previously, press the Learn/Test button
now to complete learning.