©
2008 Directed Electronics—all rights reserved
Timer Mode
This unit can be programmed to start and run the engine every three hours,
for a maximum of six cycles. The engine will run for the programmed run time
and then shut down. After three hours, the system will restart the engine.
Important!
Timer Mode should be used only in open areas. Never start and run
the vehicle in an enclosed space such as a garage or carport.
To enter or exit timer mode with the transmitter:
Remote start the vehicle by pressing
twice and then press
.
The parking lights will flash rapidly four times.
After 1 second the car will start and the timer mode will run for the speci-
fied time period.
The engine may run for its programmed run time, or the transmitter can be used
to shut down the engine. Either way, the remote start system will restart the
engine again in three hours. Timer Mode is exited automatically after the sixth
run cycle.
The same procedure may be used to enter or exit Timer Mode using the remote
transmitter and will slowly flash the parking lights 4 times when exiting.
To exit timer mode manually:
Make sure the remote start system is not operating the engine.
Turn the ignition on.
Timer Mode will be exited and the parking lights will flash slowly four times.
To enter turbo timer mode with a manual transmission:
Perform the manual transmission procedure (See p.78),
with the door open.
Transmit the timer mode feature with the remote by pressing two-times,
and then
. After exiting the vehicle, arm the alarm and the vehicle will
remain running for the programmed runtime. (The remote start feature is still
enabled).
Note:
The Bitwriter can change the amount of times the remote start will acti-
vate and the intervals between activations in timer mode.
1.
2.
3.
1.
2.
Summary of Contents for Responder LE 3.3X
Page 90: ...N5202X 2008 02 ...
