42
P2544PM | 2021-02
Apex Tool Group
3
EN
3.11.2
Software update
>
Fig. 3-40: Submenu – Software update
Carry out the software update via WLAN connection using the
Cordless RF Configuration
software.
1. Switch the tool on.
2. Install the
Cordless RF Configuration
software, see document
P2372JH.
3. Make sure that the WLAN settings on the tool are configured so that the software update can be per-
formed via a WLAN connection.
4. Activate the
TCP/IP direct
interface in the
Communication with tool
tab and enter the IP address of the
tool.
5. Open the
Tool identification
tab.
6.
To change the software o
n the tool, press <Software Update>.
7. Confirm the following messages with <ja>.
8. Select the appropriate
.tma
-file with the selection dialog.
Fig. 3-41: Update process
→
The progress is shown on the tool display.
→
The software update is finished when the tool restarts.
100
Note
Do not switch off the system after software update is completed.
The update can take up to three and a half minutes.
Wait until the software update is completely finished.
As soon as
SW update done!
is displayed
,
the software update starts in background
.