ClearWater Lights Dixie, Installation Manual

Page: 6 / 12

Page 6
Step 4: Wiring
Electrical:
• (1) Mount the power relay box in a safe location. Secure with a zip tie. (It
is a good idea to face the relay box with the wires coming out the bottom.)
• (2) Route the two Black connectors for the lights to a convenient location
where they will not interfere with steering or any other moving parts.
• (3) Install the 3-way switch in a convenient location. A 7/32” hole will have to be
drilled in a panel to flush mount the switch.
• (5) Using Posi-tap, attach red (turn on wire) to a switched 12v wire. Be sure not
to use a Low beam headlight wire on H4 headlight bikes or else the lights will
shut off when the high beam is activated.
• (6) Install connectors as shown in the wiring diagram on page 6.
• (7) Run the Red and Black power wires directly to the battery. The fuse
will protect the system in the event of a short.
High Beam Feature:
Locate your bike’s High Beam headlight hot (+) lead. This will
make your lights go to full power when you turn on your high beam. Use
a Posi-tap to connect one of the white wires from the relay box to this
wire. It does not matter which white wire you use; both trigger the same
way. If you do not want to use this feature, simply tuck the white wire
away in a neat fashion.
Horn Feature:
Locate the Horn’s hot (+) lead. This will make your lights flash
to full when you sound your horn. Use a Posi-tap to connect one of the
white wires from the relay box to this wire. It does not matter which white
wire you use; both trigger the same way. If you do not want to use this
feature, simply tuck the white wire away in a neat fashion.
Wire Routing:
(Please consult owners manual for wiring diagram and color codes)
• Be sure to route wires so that they cannot become tangled or caught
in either a suspension part or steering part. Check movement of both
steering and suspension before riding the bike.
• It is sometimes helpful to follow existing wire routing.
Page 5