ClearSpan 105624, Manual

Page: 13 / 23

13
CLEARSPAN
™
CARPORTS
Revision date: 10.27.08
Shelter shown above may show a different length and
support structure.
Shelter shown may show
a different length
and application.
Customer-Supplied Fasteners
Customer-Supplied Fasteners
ATTACH END PANEL
Gather the parts:
• End panel assembly
• Customer-supplied fasteners
• Measuring tape and scissors
NOTE:
If in doubt, consult the advice of a professional
contractor (if needed) and purchase the correct fasteners to
attach end panel(s) to the support structure.
Assembly Procedure:
1. While standing inside the shelter, start at the peak of
the end rafter and pull the end panel over the top of the
rafter so the panel edge is wrapped to the inside of the
rafter.
NOTE:
Use additional help to pull the end panel in
position over the entire rafter. It may be helpful to have
someone stand on the conduit to keep it on the ground
when stretching and attaching the end panel.
2. Move to the lower section of the end panel and secure
the panel to the building, support wall, or posts using
customer-supplied fasteners approximately 12" up from
the conduit.
3. Evenly space the fasteners along the rafter and pull the
end panel tight as the fasteners are installed.
4. After securing the lower section of the end panel, move
to the top, stretch the panel to remove wrinkles, and
secure it in place as previously described.
NOTE: Install the fasteners on the backside or inside
surface of the rafter to prevent damage to the main
cover.
5. After installing the first end panel, repeat the steps to
attach the remaining optional end panel if purchased.
NOTE: The excess end panel material can be
removed. If the excess is removed, allow at least six
inches (6") to remain beyond the fasteners. If the panel
is removed for any reason, the extra material is used to
pull the panel tight.
6. After installing the optional end panel(s), install the end
ratchets.