ClearOne NetPoint Firewall Traversal, Installation And Setup Manual, Page: 19 / 35

NetPoint Firewall Traversal Server: Installation and Setup Manual 19
Name Description
Outbound TCP signaling
port The port in the firewall through which the system routes TCP/IP signals.
This port must be identical on both Collaborate Central and NetPoint servers. If
you decide to change the Outbound TCP Signaling Port before establishing
the connection with NetPoint, you have to click on the Management Pages
button, and change the port number in the NetPoint configuration page
accordingly.
Outbound UDP signaling
port
The port in the firewall through which the system routes UDP signals. This
parameter is configured automatically based on Outbound TCP Signaling Port
(+1).
Outbound UDP media port The port in the firewall through which the system routes data. This parameter
is configured automatically based on Outbound TCP Signaling Port (+2).
H460 RTP port Low/High The range of ports in the firewall through which the system routes data, when
communication is external to the organization network.
H323 RTP port Low/High The range of ports in the firewall through which the system routes inbound and
outbound data.
TCP connection timeout Frequency for sending Keep Alive messages over the TCP/IP connection, if
applicable.
UDP connection timeout Frequency for sending Keep Alive messages over the UDP connection, if
applicable.
RAS message timeout Amount of time until an unanswered Registration Admission Status (RAS)
request to the Collaborate Central is discarded.
VERIFYING NETPOINT STATUS
The Status tab allows you to verify all indications concerning the connection, and allows
you to stop and start the NetPoint service.