CONVERGE PRO 2 USB EXPANDER
6
CONNECTIONS
Connect the USB expander to:
•
Peripheral Link (P-Link) In or Power-over-Ethernet (PoE) power
injector with a CAT5e or CAT6 cable,
•
A laptop/PC/MAC, other audio devices, or VC codec with the Audio
USB port via the Type A to Type B USB cable,
•
A remote control serial device (such as ClearOne’s Touch Panel
Controller, or any 3
rd
-party controller) with the RS232 port via the 3
Position Terminal Block Plug 3.81mm GY connector.
2. Remove affected ceiling tile and adjacent tiles required for access.
3. Install fasteners/anchors.
4. Install expander unit at determined location.
5. Use drywall saw to cut hole into finished side of ceiling tile at
marked location.
6. Route the cables through the hole.
NOTE:
Carefully run connected cables so they do not block the
cooling vents or put strain on the connectors.
NOTE:
Anchors and screws used to mount the expander are not
provided and must be selected by installer for the type of ceiling
material supporting the expander. Take care while drilling and installing
anchors so ceiling material does not tear out and weaken attachment.