Proprietary Information: Not for use or disclosure except by written agreement with Clearfield.
56
FieldSmart
®
Fiber Active Cabinet (FAC) 900
Installation Manual
_________________________________________________________
Installing the Stabilizer Bracket(s)
This topic describes how to install stabilizer brackets on the FAC 900 and EXM. The bracket(s) is required for an H-frame
mounting.
To install stabilizer bracket(s) for an H-frame
Step 1:
Step 2:
Step 3:
Step 4:
Position the stabilizer bracket against the rear enclosure wall in the location where you removed the lifting
detail, aligning the (2) bracket holes with the counterpart holes in the cabinet. For low profile configurations the
(2) bracket holes are on top; for high profile configurations the (2) bracket holes are on the bottom (as shown in
the illustration below).
Reinstall the hardware set aside from the lifting detail to secure the bracket to the cabinet.
Drill (4) 1/8" pilot holes into the top horizontal beam through the bracket holes.
Install (4) 3/8 x 1.50 LAG screws, 3/8"split lock washers and 3/8" flat washers to attach the bracket to the
H-frame.
