FSII-BASE-II v1.2 Release Note
Page 3 of 5
This Document Part No. 399G171 Rev D
1
Introduction
1.1
Scope
This document describes the release of the FSII-BASE-II product family
1.2
v1.2
Issues addressed in this release
Beltpack input/output gain not properly re-applied after beltpack power cycle
Audio level overridden when applying change to role
MV] shown on keyset even if only one role is selected
Stuck cross-point when removing yourself from a group
Log file over-run fixed
FSII-BASE-II USB - If I plug in an already registered beltpack it disconnects and may connect to a
different system on power cycle
Unable to press/unpress talk/call when in front panel menu
1.3
v1.1
Reason for change from v1.0 to v1.1
Beltpacks continued to receive audio from the 4W interface after deleting the role.
1.4
v1.0 – First Release
FSII-BASE-II product Family
FSII-BASE-II
FreeSpeak II Digital license-free wireless base station with XLR-4M headset connector. Supports
up to 25 Beltpacks and 10 antennas. (Two antennas can connect to the base station directly or up
to 10 antennas can be connected by using two x PD2203 splitters) The base station has
connections for four 2-wire party-lines (CC or RTS) with auto nulling, and four 4-wires plus a
dedicated SA output and dedicated program audio input, along with 4 relays.
FSII-BASE-II-X5
FreeSpeak II Digital license-free wireless base station with XLR-5F headset connector. Supports up
to 25 Beltpacks and 10 antennas. (Two antennas can connect to the base station directly or up to
10 antennas can be connected by using two x PD2203 splitters) The base station has connections
for four 2-wire party-lines (CC or RTS) with auto nulling, and four 4-wires plus a dedicated SA
output and dedicated program audio input, along with 4 relays.
