Encore TWC-703 Adapter
3.4
Internal Configuration
The TWC-703 Adapter has three jumper switches located on the internal PCB intended for
operating conditions that are rarely expected to be experienced. These are:
l
J8 - used to configure auto-termination of channel A. Default is
ON
.
l
J9 - used to configure auto-termination of channel B. Default is
ON
.
l
J10 - used to enable or disable RTS Compatibility Mode. Default is
OFF
.
Note:
The TWC-703 Adapter applies termination per channel if there is no power on Clear-Com
channel A or B. In this condition the TWC-703 Adapter assumes it is in Standalone Mode.
Note:
Certain RTS TW beltpacks can create audio interference (buzz) on channel B during call
signal. This circuit applies an additional termination to channel B to stabilize the
interference.
Page 15
