Eclipse
|
Upgrade Guide
Page 77
6
Upgrading the Eclipse HX-PiCo
This chapter describes how to upgrade the Eclipse HX-PiCo matrix, including the PROM,
FPGA and application code.
The Eclipse HX-PiCo PROM is different from the PROM used with the CPU cards, which
are fitted to the Eclipse HX-Median, Eclipse HX-Omega and Eclipse HX-Delta matrices.
Care should be taken to ensure that the correct PROM is fitted.
Note:
If you are upgrading your PiCo to an HX-PiCo please contact your Clear-Com
representative to establish if your hardware is HX ready. If your PiCo hardware is not HX
ready then this is a factory only upgrade.
Note:
This guide is laid out in the order in which you must upgrade your Eclipse HX software
and hardware devices. For a quick reference to upgrading your system, see
3Quick reference: Upgrading to Eclipse HX
Note:
The HX-PiCo mainboard needs a factory hardware modification.
Eclipse HX devices are powered by
mains voltage
. Unless
specifically advised to the contrary,
disconnect
mains supply before
carrying out any maintenance or repair tasks. Observe precautions
for handling electrostatic sensitive devices.
6.1
Changing the Eclipse HX-PiCo PROM
Note:
When you change the Eclipse HX-PiCo PROM, you must also change the Eclipse HX-PiCo
RAM (from 128Mb RAM to 256Mb RAM). See
6.2 Changing the Eclipse HX-PiCo RAM
below.
To upgrade the Eclipse HX-PiCo PROM:
1)
Ensure that you have the following equipment:
Required equipment
Description / comments
2MBit PROM device (ST
M27W201 or equivalent).
-
PROM Programming Unit
You will also require the appropriate
programming software for the unit.
The appropriate S record
file for the Eclipse HX-PiCo
boot PROM.
You can find the
S
record file on the Drivers
USB:
Drivers USB > ECLIPSE DRIVERS > PiCo-
HX_PiCo_E-32 > xxxxxx
–
Boot PROM
(where
xxxxxx
represents the part number).
Table 6-1: Required equipment
2)
Ensure that the Eclipse HX-PiCo is powered off. Remove the lid of the device.
