Claypaky CL2017, Instruction Manual, Page: 5 / 12

5
Mini-B ParLED Aqua
Switching on the projector - Fig. 7
Plug-in the power connector. The projector starts the reset procedure. At the same time, the following information scrolls on the display:
Mini-B ParLED AQUA
Version X.X.X
Date - Hour
The control panel (Fig. 7) has a display and buttons for the complete programming and management of the projector menu. The display can be in one
of two conditions: standby or setting status. When it is in standby, the display shows the projector’s DMX address.
During the setting status, after a wait time (about 30 seconds) without any key having been pressed, the display automatically returns in standby. It
should be noted than when this condition occurs, any possible value that has been modified but not yet confirmed with the ENTER key will be cancelled.
Dmx Address
001
MiniB ParLED Aqua 24°C
Ext.8Bit DMX
Menu
Enter
Up
Down
7
Connecting to the control signal line (DMX) - Fig. 6
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic impedance, 22-24 AWG, low capacity. Do not use
microphone cable or other cable with characteristics differing from those specified. The end connections must be made using XLR type 5-pin male/female
connectors. A terminating plug must be inserted into the last projector with a resistance of 120Ohm (minimum 1/4 W) between terminals 2 and 3.
IMPORTANT: The wires must not make contact with each other or with the metal casing of the connectors. The casing itself must be connected to the
shield braid and to pin 1 of the connectors. IP65 line is recommended.
SIGNAL
SCREEN
DMX 512
5 PIN
1
2
3
4
5
SIGNAL
Ethernet
6
Continue ➔
3.3 Connecting the control signal line: DMX / Art-Net
3.4 Switching on the fixture and basic SetUp
001
MiniB ParLED Aqua 24°C
Ext.8Bit DMX
Menu
Enter
Up
Down
001
Min iB Par LED Aq ua 2 4°C
Ext .8B it DM X
Menu
Enter
Up
Down
Reversal of the display - Fig. 8
To activate this function, press UP and DOWN keys simultaneously while the display is in standby. This status will be memorised and maintained even
for the next time it will be switched on. To return to the initial state, repeat the operation all over again.
Setting the projector starting address
On each projector, the starting address must be set for the control signal (valid addresses from 1 to 501).
The address can also be set with the projector switched off.
8