Clavister SG4300 Series, Getting Started Manual, Page: 30 / 68

Running the Wizard Again
Once the wizard has been successfully finished and activated, it cannot be run again. The exception
to this is if the Clavister Security Gateway has its factory defaults restored in which case the unit
will behave as though it were being started for the first time.
Uploading a License
If the wizard has been run or not, the Web Interface can now be used to upload a valid license to the
Clavister Security Gateway. Without a license, CorePlus will run in demonstration mode which
means that it will cease to function after two hours of operation (restarting the system will re-enable
CorePlus for another two hours). The steps for license upload are:
• Using a web browser, surf to the Clavister Customer Web (this can be found at
https://clientweb.clavister.com) and register for the first time. You will require your Clavister
registration key to do this. For the SG4300 Series this key can be found written on the label on
the underside of the unit. If you are already registered as a customer then you will need to login
to the Customer Web.
• The Customer Web system will ask for a MAC address to associate with the Clavister license.
This is the hardware Ethernet address associated with one of the Ethernet interfaces on the unit.
On the SG4300 Series, the MAC address can also be found written on the label on the underside
of the hardware.
Alternatively , a MAC address can be read from the output of the ifstat CLI command (this can
be entered via the serial console).
• Now download a valid .lic license file from the Customer Web to the hard disk of the
workstation.
• In the Web Interface menu bar, go to Maintenance > Upgrade and use the Browse button to
select the license file, then upload it. As soon as the license is uploaded, demonstration mode
will end and CorePlus will be restricted only by the limitations of the license.
3.2. Web Interface and Wizard Setup
Chapter 3. CorePlus Configuration
30