2.
While the unit is powered up, push in the recessed reset button on the unit with a
suitable pointed tip tool and keep it pushed in. A suitable paper-clip could be used to do
this. The button can be found above the power LED.
3.
Continue holding the button in for at least 10 seconds. The status LED will blink and
when the blinking stops the reset is being performed.
4.
If a console was connected in step
1
, the console output will indicate that the hardware
has successfully been reset to its factory defaults.
5.
After completion of the reset, the NetWall 6000 Series unit can now be set up again as
though it had never been previously configured.
Caution: The local console credentials will be reset
The local console login credentials will be reset to the default values of username
admin
and password
admin
.
Chapter 8: Resetting to Factory Defaults
92