w w w . c l a s s i c
e x h i b i t s . c o m
866.652.2100
© 2013
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - VK-1950 - Lightbox Assembly
Steps:
1) Attach lower vertical extrusions [2,3] to base plates [1] using screws.
2) Attach upper vertical extrusions [2a,3a] to lower vertical extrusions [2,3] as shown in detail.
3) Connect curved horizontals [4,4a,5,5a] together as shown.
4) Attach horizontal assemblies between vertical assemblies [2/2a,3/3a] as shown.
5) Apply blocker fabric to
velcro
on outside of horizontals [5/5a) and verticals.
6) Attach SuperNova light to verticals [2/2a,3/3a] and horizontals [5,5a] as shown,
connecting connectors together.
7) Attach SEG graphics to front SEG groove according to detail below.
8) Attach wings to A-10 clamps as shown.
Item Qty Description
1
2
Base Plate
2/2a
1/1 45” Half Round Vertical Extrusion
3/3a
1/1 45” Half Round Vertical Extrusion
4/4a 2/2 44.5041” Z45 Horizontal Extrusion
5/5a
2/2 46.6892” Z45 Curved Horizontal Extrusion
Velcro:
Outside/Bottom Edge
Velcro:
Back
Outside
Edge
Velcro:
Outside/Top Edge
**
Note:
the opening
of
SEG
extrusions must
be positioned outward
from the light box.
1
1
2
2a
3
3a
4
4
4a
4a
5
5
5a
5a
*
*
*
Screws
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
Graphic: To Ensure Proper Fit
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
SuperNova Lights:
Attach to inside of verticals [2/2a,3/3a]
and top of curved horizontals [5]
Velcro:
Back
Outside
Edge
SuperNova Lights:
Attach to inside of verticals [2/2a,3/3a]
and bottom of curved horizontals [5a]
Tighten set screw to
secure A10 to extrusion.
A10 Clamp Detail
Tighten knob to secure
header/wing in place.
