background image

Trailering

To use your Classic WaveGear

®

 

Personal Watercraft Cover when 

trailering you MUST use the 

trailering strap. Trailering without it 

will invalidate your warranty.

1. Be sure that you have installed 

your cover tightly and that all  

ropes are firmly attached.

2. Tie a rope to the bow D-ring 

on the cover and cinch tight to 

the trailer or pull the cover down 

over your watercraft’s trailer 

attachment ring.

3. Sewn along the top of your 

cover you will find webbing loops. 

Thread the trailering strap under the 

webbing loop that will best provide 

the clearance to cinch your cover 

down toward the seat behind  the 

steering column. Run the strap 

under the watercraft, thread the 

strap into it's buckle and tighten 

the strap to secure your cover. Be 

sure that there are no loose areas 

that can flap in the wind while you 

drive.

 WARNING

When transporting your P.W.C. on a 

trailer or an open vehicle be sure to 

use and tighten all the straps—the 

cover could blow off and cause 

injury to others.

 CAUTION

Failure to use and tighten all the 

straps when transporting your 

P.W.C. on a trailer or an  

open vehicle can cause damage to 

your cover or vehicle.

insTallaTion

1. Cover any sharp points with 

cloth or a sponge to avoid 

stressing or tearing your cover.

2. Drape your cover over your 

personal watercraft (P.W.C.) with 

the tapered end marked “FRONT” 

at the bow.

3. Pull your cover below the rub 

rail around your entire P.W.C.

4. Tie one end of the supplied 

nylon rope to a side D-ring sewn 

into the bottom hem of the 

cover. Pull the rope under the 

watercraft to the corresponding 

D-ring on the opposite side. 

Allowing enough rope to make a 

knot, cut off the rope and tie into 

the second D-ring. Repeat with 

remaining D-rings.

5. Carefully singe the ends of the 

rope with a match or lighter to 

prevent fraying of the ends.

6. Adjust and tighten cover as 

necessary for your watercraft.

instructions:

 

Personal Watercraft Cover

4. After driving a mile, recheck all 

straps, adjusting as necessary for 

a tight fit. 

Care and Cleaning

If your watercraft cover becomes 

dirty, it can be cleaned with 

lukewarm water and a soft brush. 

DO NOT USE SOAP, or clean in 

washing machine - it can damage 

the protective coatings on your cover.

sTorage

To avoid mildew be sure your cover 

is completely dry before you store 

it for any extended period in its 

attached stuff sack.

10cOW55_11360

20

-

034

-

031001

-

00

20

-

035

-

041001

-

00

20

-

034

-

031001

-EC, 

20

-

035

-

041001

-EC, 

20

-

034

-

031001

-CT, 

20

-

035

-

041001

-CT

CLASSIC ACCESSORIES, INC.
KENT, WA USA 

98032  

©

2013

c l a s s i c a c c e s s o r i e s . c o m

Reviews: