Classeq D 400, User Manual

Page: 27 / 224

Classeq Under Counter Range - User Manual
21
UK
7.3 Limescale Build Up
For best results ensure your warewasher is operated with soft
water so that limescale does not build up.
If your warewasher is connected to an external Water Softener,
ensure this is routinely regenerated as per the manufacturer’s
instruction manual.
If your warewasher has an internal Water Softener fitted ensure
the salt level is maintained as per the instructions in this manual.
If your warewasher is operated with hard water, without the
relevant water treatment, the internal workings and water lines
can become scaled, your washing results will deteriorate and the
warewasher could be damaged. For more information on hard
water refer to Water Supply and Connection (
►4.5
).
Caution
Damage to the warewasher caused by limescale
will NOT be covered by the manufacturer’s
warranty (
►12
).
7.4 Regular Maintenance
7.4.1 Water softener salt (if fitted)
When the salt level inside the Salt Reservoir gets low the Refill
Salt indicator will illuminate on the display.
The salt should be replenished as soon as possible to avoid
limescale from building up in your warewasher. To refill the Salt
Reservoir follow the instructions below:
1. Open the door to the warewasher.
2. Remove the right hand Basket Guide.
3. Remove the Salt Reservoir Cap at the back right hand
corner of the Wash Chamber.
4. Using the Salt Funnel supplied, fill the Reservoir with
granulated salt.
5. Wipe away any excess or spilt salt from the Wash
Chamber and the Reservoir opening.
6. Refit the Salt Reservoir Cap, ensuring that the Cap is
fitted flat and secure.
7. Do not overtighten the salt reservoir cap.
8. Drain down the warewasher and refill to remove any
residual salt water after refilling the reservoir.
Note: The Refill Salt indicator may stay illuminated for up to
three complete wash cycles after filling / refilling the Salt
Reservoir with salt.
Caution
DO NOT run the warewasher if there is no salt
in the Salt Reservoir, as this will allow limescale
to build up. Limescale deposits in the
warewasher will invalidate the warranty.
Caution
DO NOT add any chemicals, such as detergent
or rinse aid to the Salt Reservoir. These will
cause damage to the
warewasher .
Caution
Only use granulated salt (max. grain size 5 – 7
mm) . Salt tablets are not suitable.
Caution
If the Salt Reservoir Cap is not properly secured,
water and/or chemicals can leak in or out of the
unit causing damage to the
warewasher .
7.5 Descaling
You can de-scale the Wash Tank of your warewasher yourself
with the help of the following notes; to de-scale the Rinse Boiler
you will need to contact your service engineer or
Classeq .
Warning!
Wear the correct Personal Protective Equipment,
e.g., gloves and goggles, when handling
chemicals and observe all safety notes and
dosing recommendations printed on the
packaging.
Caution
De-scale chemical must not remain in the
warewasher for more than 2 hours.