English
GREAT BRITAIN • CUSTOMER SERVICE
tel: 020 8247 9300
internet:
www.clasohlson.co.uk
Ver
. 20150721
Power inverter
Art.no 32-7733
Please read the entire instruction manual before using the product and then save it for future reference.
We reserve the right for any errors in text or images and any necessary changes made to technical data.
If you have any questions concerning technical problems please contact our Customer Services.
Voltage selection
1. Select the proper voltage. Check the product’s
rating plate or count the number of batteries
for calculation first. Each battery has a 1.5 V
value (2 batteries = 3 V, 4 batteries = 6 V,
8 batteries = 12 V).
2. Set the adaptor’s selector switch to the proper
voltage.
Checking battery polarity
1. Select the proper adaptor tip. Check the polarity
of the product to be run off the polarity inverter.
Connect the adaptor tip so that the (+) symbol
lines up with “TIP” on the power inverter cord
which corresponds to the power inverter’s
positive centre conductor pin.
Positive centre conductor pin symbol:
Fuse replacement
Twist the plastic tip on the cigarette lighter plug
anticlockwise and check the fuse. If the fuse has
blown or if you are uncertain, replace the fuse.
Only replace with 3 A rated fuses.
Specifications
Input voltage
12 V DC
Output voltage
Adjustable
1.5–3–4.5–5–6–9–12 V DC
Max 1500 mA
Safety guidelines
1. Always check for correct voltage selection
and polarity since any driven device will
be susceptible to damage by constant
overvoltage and/or reversed polarity.
2. Do not use the power inverter for devices that
use currents exceeding 1.5 A.
3. Never try to dismantle the adaptor.
4. Pull the plug out of the cigarette lighter socket
when the power inverter is not in use.
Disposal
The product should be disposed of in accordance
with local regulations. If you are unsure how to
proceed, contact your local council.
Note:
Selecting an incorrect polarity setting may
cause permanent damage to the product being
connected.
2. Connect the adaptor tip to the device to
be powered.
3. Connect the power plug to your car’s cigarette
lighter socket. The green LED should then
come on. If no light is seen, refer to the
Fuse
replacement
section below.
4. Turn the load device on. If the device does not
power on, turn off the power immediately and
check the polarity as in shown in steps 1–3
above.
Positive centre pin
