STAINLESS STEEL VACUUM FLASK
MODEL : VFH1000
PART No : 4560500
0703
Using Your Flask
For Best Results Always preheat or precool your flask
before filing with your chosen drink.
To preheat or precool, fill the flask with hot or cold water
and allow to stand for 1-2 minutes. Empty flask and fill
with prepared drink to just below the stopper. DO NOT
overfill.
If adding ice cubes or soup with meat pieces etc, it is
possible to remove the flask top completely by unscrewing
anticlockwise. Refit by screwing in clockwise direction until
tight.
Ensure the pressure release valve is closed by pressing and
releasing the button on the stopper (valve is closed when
button is up).
Screw stopper down firmly, tilt flask over sink to check for
leaking.
Place small cup on top of flask and screw large cup on
until it clicks into position (cup handle aligned with carry
handle).
Attach carry strap if required by simply pushing strap
connectors into the slots, top and bottom of handle, until
they click into place. Test strap is secure by gently pulling.
To remove the strap, squeeze the sides of the connector
with thumb and forefinger to release the securing clips,
and gently pull out.
STAINLESS STEEL VACUUM FLASK
MODEL : VFH1000
PART No : 4560500
0703
Using Your Flask
For Best Results Always preheat or precool your flask
before filing with your chosen drink.
To preheat or precool, fill the flask with hot or cold water
and allow to stand for 1-2 minutes. Empty flask and fill
with prepared drink to just below the stopper. DO NOT
overfill.
If adding ice cubes or soup with meat pieces etc, it is
possible to remove the flask top completely by unscrewing
anticlockwise. Refit by screwing in clockwise direction until
tight.
Ensure the pressure release valve is closed by pressing and
releasing the button on the stopper (valve is closed when
button is up).
Screw stopper down firmly, tilt flask over sink to check for
leaking.
Place small cup on top of flask and screw large cup on
until it clicks into position (cup handle aligned with carry
handle).
Attach carry strap if required by simply pushing strap
connectors into the slots, top and bottom of handle, until
they click into place. Test strap is secure by gently pulling.
To remove the strap, squeeze the sides of the connector
with thumb and forefinger to release the securing clips,
and gently pull out.