5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
NOTE:
Using the battery test button whilst the battery is on charge gives
false information. When the battery is on charge, the level
indicator glows RED: pressing the battery level test button will
cause the indicator to turn GREEN. Release the button and the
indicator returns to RED.
To charge the battery from the 12v car battery, ensure the lamp is switched off
and connect the small plug of the DC charger into the AC/DC charging
socket. Plug the other end into the cigarette lighter socket.
DO NOT
leave on charge for long periods, (more than 4 hours), as the result
may be a flat car battery.
Use either the AC or the DC charging adapters supplied to charge the
battery.
If you plan to store the lamp for long periods, it is recommended to fully
charge the battery first using the AC charger.
This will ensure the longest
possible battery life.
When not in use, it is recommended to recharge the battery at least every four
months.
A fully charged battery will give approximately 5 hours of continuous use,
(lamp only).
OPERATING INSTRUCTIONS
1. Ensure the 12v power cable (Item 7 - Fig. 1), is firmly connected between
the 12v power socket on the back of the power pack and the 12v DC input
socket on the back of the lamp. Switch the lamp on using the ON/OFF
switch.
2. Loosen the adjusting knobs and adjust to the desired angle, retighten both
knobs once desired position is found, DO NOT ovetighten.
3. The unit can be used as a 12v power supply to power other 12 DC
appliances at the same time as using the lamp, using the 12v Power socket
and the twin socket adapter. Using power tools etc this way will obviously
shorten the use time.
The lamp can be run directly from any 12v DC supply using the correct cable,
e.g. the 12v power cable supplied can be connected to the 12v DC input
socket and the car cigarette lighter socket.
NOTE:
The 12v power cable and 12v DC charger and AC charger are
stored in the bottom of the battery pack. To access them, turn the
lamp upside down and slide the cover towards the cushioned
base, (front).
